Accessories; Maintenance - RIDGID R350RHF Operator's Manual

MAINTENANCE

 Begin inspection:
• Without pulling the trigger, press the workpiece con-
tact against a workpiece several times. The tool must
not actuate.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away and pull the
trigger several times. Hold the trigger in this position
for a minimum of 5 seconds The tool must not actuate.
• Load fasteners, then press the workpiece contact
firmly against the workpiece and pull the trigger. The
tool must actuate.
• With the workpiece contact still depressed, release
the trigger. The driver must return to its up position.
 Disconnect the air supply from the tool and remove all
fasteners.
 Select the contact actuation mode (
 Reconnect the tool to the air supply.

ACCESSORIES

To order parts and maintenance kits, call 1-866-539-1710.
Driver Maintenance Kit ....................................................................................................................................079077050701
Overhaul Kit .....................................................................................................................................................079077050702
Oil and Wrench Kit...........................................................................................................................................079077050703
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
 Begin inspection:
• With the workpiece contact not engaged on the
• Load fasteners, then fully depress the trigger and push
 Disconnect the air supply from the tool and remove all
fasteners.
 If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool to
operate in the manner that best fits your application.
 Set the depth of drive according to the Depth-of-drive
Adjustment section in this manual.
 Connect the tool to the air supply and load the proper
). fasteners for the desired application. Repeat this checklist
before using the tool each day, or if the tool is dropped
or damaged in any way.
13 – English
workpiece, point the tool down and away. Pull the trig-
ger. The tool must not actuate.
the workpiece contact against a workpiece. The tool
must actuate.