Summary of Contents for Universal Electronics NevoConnect NC-50
- Page 2 NevoConnect NC-50 Requirements You will need a NevoConnect NC-50 in each room or equipment closet containing devices to be controlled. You must configure each Nevo Controller to send commands via NevoConnect NC-50.
- Page 3 NevoConnect NC-50 Features 4 IR Blaster LEDs and a Front Panel Activity LED (all behind the plastic) Removable 3.5mm Addressable Z-Wave Programmable Ports Antenna USB port Program Power Button Connection Port Activity LEDs IR Signal Strength Power Status LED Adjustment Pots...
- Page 4 Wireless IR Control In a wireless setup, NevoConnect NC-50 can simply be set so that the IR blaster on the front is within the IR range of the devices to be controlled: IR receiver on device 180° 30° 15.24 m 15.24 m...
- Page 5 For Nevo IR Emitters, peel off the paper from the adhesive label and stick the IR transmitter directly on top of the device’s IR receiver. Connect the power adapter to NevoConnect NC-50’s rear panel, then to a power outlet. Connecting to a Z-Wave Network...
- Page 6 Primary Controller NevoConnect NC-50 serves as a Static Controller and should be selected as the Static Update Controller by the Primary Controller. NevoConnect NC-50 cannot act as a Primary Controller. The following are processes that require input directly at NevoConnect: •...
- Page 7 If you are using a Nevo Controller as the Primary Controller, step by step directions are provided on-screen. Create New Primary This is initiated only from a NevoConnect NC-50 that has been previously configured as the Static Update Controller. Use this to create a new Primary Controller if the original Primary Controller is lost or damaged.
- Page 8 You can confirm that Nevo is now the Primary Controller by selecting the Z-Wave option from the Settings menu. Soft Reset To initiate a soft reset of NevoConnect NC-50 hardware, press the reset button on the bottom panel. You will see the Power LED blink. Factory Reset...
- Page 9 NOTICE: Nevo, Nevo , NevoStudio, NevoStudio Pro and NevoConnect are registered trademarks or trademarks of Universal Electronics Inc., in the United States and/or other countries. Other product and company names may be trademarks of their respective companies. FCC NOTICE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
- Page 10 The user is cautioned that changes and modifications made to the equipment without the approval of the manufacturer could void the user’s authority to operate this equipment. FCC ID: MG310370 IC ID: 2575A-URC1037 Copyright 2007 Universal Electronics Inc. NCQGP101007 Document version...