Subscribe to Our Youtube Channel
Related Manuals for Vista M1
Summary of Contents for Vista M1
- Page 1 - 1 - www.vistacnc.com VistaCNC M1 CNC Control Pendant for LinuxCNC - 1 - www.vistacnc.com M1 Pendant LinuxCNC Manual v. 1.0...
- Page 2 WARNING E-STOP button in iMach M1 CNC Control Pendant only provides Emergency STOP signal to LinuxCNC application. For further protection in CNC operation, other emergency protection methods may be needed.
- Page 3 Step, Velocity and Continuous mode jogging through MPG. Feed rate, Spindle speed, and Slow Jog rate change through MPG. Program Cycle Start and Stop control buttons. 3 Axis selections. 3 custom control functions. - 3 - www.vistacnc.com M1 Pendant LinuxCNC Manual v. 1.0...
- Page 4 LinuxCNC if the pendant was used with other CNC application or a newer FW version is available. The upgrade application needs to be run under XP or Win7 PC. Refer to “M1 LinuxCNC Installation Instruction” to install driver and other files, and add lines to the .ini file.
- Page 5 In CONTINUOUS mode, axis moves at constant speed at maximum axis speed overridden by feed rate overridden rate. 2.4 CONTINUOUS RATE In C% mode, turning MPG changes current feed overridden (FO) rate. It has the function of - 5 - www.vistacnc.com M1 Pendant LinuxCNC Manual v. 1.0...
-
Page 6: Function Buttons
When the program is in RUNNING state, 3 axis selection LEDs flash one by one. When the program is in PAUSE state, all 3 axis selection LEDs flash twice in the first half second and stop flashing in the next half second. - 6 - www.vistacnc.com M1 Pendant LinuxCNC Manual v. 1.0... - Page 7 Shipped with10' High Speed USB cable. Extendable to 15’ with extension cable, or to 45’ with USB hub cables. Size (over all) 7"(L) x 2.6"(W) X 2.5"(H) - 7 - www.vistacnc.com M1 Pendant LinuxCNC Manual v. 1.0...
Need help?
Do you have a question about the M1 and is the answer not in the manual?
Questions and answers