Body Placement; Lcd Boot Screens; Selecting 2 Channel Or 4 Channel Operation - Lectroso Quadra Digital IEM System Instruction Manual

Body Placement

Position the receiver on a belt, guitar strap, wardrobe,
etc. so that the antennas are oriented vertically and not
touching a metallic surface. Make sure the antennas
are on the outside of thick or metallic costuming so the
antenna whips will be out in the open. For maximum
receive sensitivity, it is good practice to keep the an­
tenna whips from direct contact with a person's body.

LCD Boot Screens

The boot sequence will briefly display the company
logo, model number and firmware revision.
If a preset is active, this screen will appear, including
the word (modified) if the preset has been edited.
Following the boot-up sequence, the receiver will re­
vert to the Main Window, showing the following:
Operating
RF Level Meter
Frequency
Operating Mode and
Knob Configuration
Rio Rancho, NM
Selecting 2 Channel
or 4 Channel Operation
Audio
Level
Meters
To access the setup menus, press the MENU/SEL
button at the upper left of the membrane panel. Press
the BACK button to back up one level or return to the
main window. The UP and DOWN arrow buttons along
the right side of the control panel allow you to navigate
between menu options and to adjust specific param­
eters within the setup screens.
Battery status is indicated by a GREEN LED. The
LED turns RED to indicate that your batteries are 2/3
depleted. FLASHING RED indicates that you should
replace your batteries as soon as possible.
The blue RF LED indicates an RF lock between the
transmitter and receiver, when lit.
The Chan. Setup screen allows you to select whether
the receiver operates in 2 channel, 4 channel or split 4
channel modes, and then how the knobs on the top of
the receiver are configured as a mixer.
Each Chan. Setup screen allows selection of 2 Chan­
nel and 4 Channel modes, plus a second line for selec­
tion of the knob configurations.
Press MENU/SEL to toggle the highlight between the
Chans and Knob lines and use the UP and DOWN
arrow keys to make selections.
NOTE: Review the individual setup options in the
following section.
Digital IEM System
2/4 channel
selection
knob
configuration
7