Split 3,4 Operation - Lectroso Quadra Digital IEM System Instruction Manual

Split 3,4 Operation

Split modes allow you to use a single M4T transmitter
running in the 4 Channel mode to send two different
2 channel stereo mixes to two different receivers or
groups of receivers using a single radio frequency.
Split 3+4 mode delivers audio channels 3 and 4 to
the tall, thin knob and the lower concentric knob. The
knobs can be set up to function in three different ways.
NOTE: the transmitter must be in 4 Channel
mode for the receiver to work in this manner.
• Master(3,4)
Also equivalent to standard IEM systems where
only stereo signal is used. The tall, thin knob is
the stereo master volume and is fed from audio
channels 3 & 4. Here, although there is audio on
channels 1 & 2 in the transmission itself, they are
muted and thus the two individual knobs do not
function.
• Master(3)+4
Feeds audio channel 3 to the master volume (tall,
thin knob) and audio channel 4 to the lower con­
centric knob for independent control.
• 3+4
The two knobs function independently with neither
one working as a master. Feeds audio channel 3
to the tall, thin knob and audio channel 4 to the
lower concentric knob for independent control.
Rio Rancho, NM
Master(3,4) mode
AUDIO CH.
3
4
MASTER
VOLUME
NO
FUNCTION
Master (3)+4 mode
AUDIO
CH. 3
FUNCTION
MASTER
VOLUME
AUDIO
CH. 4
3+4 mode
AUDIO
CH. 3
FUNCTION
AUDIO
CH. 4
Digital IEM System
NO
FUNCTION
NO
NO
FUNCTION
NO
NO
FUNCTION
11