Advertisement
Wireless Sensor Camera (Camera)
Wireless Sensor Camera (Camera)
■ VL-WD813
〈Rear view 〉
Indicator lamp
After the camera has been registered to the main monitor, you can check the camera's status and
the wireless signal status from the main monitor by checking the status of the indicator lamp.
Indicator display
Flashing green
(fast)
Transmission
status
Flashing green
(slow)
Lit green
Signal status
Lit orange
(during
Lit red
standby)
Flashing red
Parts Descriptions
A sensor has been triggered and the camera is calling the main monitor.
The camera is transmitting data to the main monitor.
Indicates the signal status from the main monitor.
● We recommend installing the camera in an area
where the status indicator is strong (when the
indicator is lit green).
Transmissions cannot be sent because there is no signal (out of range).
3
①Lens cover & Lens(inside the
cover)
②LED lights
③Indicator lamp (See the following
explanation.)
④Safety wire
⑤Sensor range cap (standard type)
4 types of lens caps (accessories)
can be fitted as required. (See the
Camera's Installation Guide.)
⑥Heat sensor
Detects changes in temperature.
⑦Microphone
⑧Speaker
⑨Register button cover
⑩Register button (behind the
register button cover)
Used when registering the camera
to the main monitor. (In case of VL-
SVH705KLC & VL-SVH705KSC, the
camera has already been registered
in the main monitor.)
⑪Heat sensor lever
Used to change the angle of the
heat sensor. (See the Camera's
Installation Guide.)
Camera's status
Advertisement
