Skoda KODIAQ 2016 Brief Instructions page 20

›
Wizard for "blind spot" monitoring - operation
At a speed of more than 15 km/h, the area alongside and behind the
vehicle is monitored by the system. At the same time, the distance and
the difference in speed between your vehicle and other vehicles in the
monitored area are measured.
When driving, the system monitors an area the size of a normal lane
width to the left and right.
If a vehicle is detected in the "blind spot" area, the system indicates
this vehicle by the warning light
The system can be activated/deactivated in one of two ways.
›
In MAXI DOT display in the Wizard menu item.
›
In the infotainment in the

System constraint
The system is unable to recognise the specific lane width by means of
sensors. Therefore it may respond to a vehicle in a lane further away in
the following scenarios, for example.
›
When driving on a road with narrow lanes or on the lane edge.
›
Driving around a bend.
The system may also respond to objects on the roadside such as crash
barriers, noise barriers or similar objects.
18
lighting up in the exterior mirror.

menu →  → Driver assistance.
›
Wizard for "blind spot" monitoring - driving
conditions and warnings
In the following situations, the indicator light in the outside mirror indi-
cates a vehicle detected in the "blind spot".
›
Your vehicle is being overtaken by vehicle
B
›
Your vehicle is overtaking vehicle
C
km. If the speed during the overtaking is even higher, then there is
no warning by the warning light.
Two warning levels
light ups - a vehicle has been detected in the "blind spot".

flashes - a vehicle has been detected in the "blind spot" and the

turn signal is switched on.
The warning is always displayed in the exterior mirror on the side of
the vehicle where a vehicle is detected in the "blind spot".
The greater the speed difference between the two vehicles, the earlier
the warning of the vehicle overtaking you is provided (by means of the
warning light).
.
A
at a higher speed of max. 10
D