Installation; Insertion In An Exm Carrier - RadiSys EXM-9 Reference

2. Installation

Before installing the EXM-9, unpack and inspect it for shipping damage.
DO NOT REMOVE THE MODULE FROM ITS ANTI
UNLESS YOU ARE IN A STATIC
LIKE MOST OTHER ELECTRONIC DEVICES
.
DAMAGE ESD DAMAGE IS NOT ALWAYS IMMEDIATELY OBVIOUS
IN THAT IT CAN CAUSE A PARTIAL BREAKDOWN IN SEMICON
DUCTOR DEVICES THAT MIGHT NOT IMMEDIATELY RESULT IN A
.
FAILURE
ENSURE THAT THE INSTALLATION PROCESS AS DESCRIBED HEREIN
IS ALSO PERFORMED IN A STATIC

Insertion in an EXM Carrier

Once the header pins are set, insertion of the EXM-9 into an EXM carrier is
straightforward. Remove a blank EXM panel from the carrier (by unscrewing the
thumbscrews) and insert the EXM-9 into the card guides.
EXM-9 front panel to ensure that the module is properly seated in the subplane and
secure it with the thumbscrews.
MAKE SURE THAT POWER TO YOUR SYSTEM IS OFF
NOT DESIGNED TO BE INSERTED OR REMOVED FROM A LIVE
.
SYSTEM
WHEN INSERTING THE EXM
,
BOARD AND MAKE SURE THE ENVIRONMENT IS STATIC
INSERT IT WITH ADEQUATE CONTINUOUS FORCE RATHER THAN
TAPPING OR HAMMERING ON IT
-
STATIC BAG
- . -
FREE ENVIRONMENT THE EXM
,
IS SUSCEPTIBLE TO ESD
- .
FREE ENVIRONMENT
Firmly press the
.
THIS EXM IS
,
AVOID TOUCHING THE CIRCUIT
- .
FREE
.
2
,
9
,
-
Page 3
2