Connectors; Figure 3. Front Panel Connectors - RadiSys EXM-9 Reference

3
Some error messages that might appear and their interpretations are
Disk boot failure. No boot disk could be found by the BIOS.
Diskette drives or types mismatch error. The BIOS setup information is inconsistent with the drives de-
tected (or absent).
Error initializing hard disk controller. The BIOS could not find the EXM-9 (e.g., missing or disabled).
Floppy disk cntrlr error. The BIOS could not find the EXM-9 (e.g., missing or disabled).
3
General failure... Usually indicates an unformatted disk or diskette.
Non-system disk. Trying to boot from a disk or diskette that is not formatted as a bootable system disk.

Connectors

The EXM-9 has two connectors on its front panel: a 40-pin IDE connector and a
34-pin floppy disk drive connector.
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40
1 3 5 7
2 4 6
1 3 5

Figure 3. Front Panel Connectors.

Page 10
EXM-9 Hardware Reference
9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39
8 10 12 14 16 18 20 22 24 26 28 30 32 34
7 9 11 13 15 17 19 21 23 25 27 29 31 33
4 0
34
2 1
2 1