General Care & Cleaning - Kenmore 790. 6409 Use & Care Manual

Hide thumbs Also See for 790. 6409:
Table of Contents

Advertisement

Care and Cleaning
Removing and replacing the lift-off oven door
To avoid possible injury when removing or re-
placing the oven door, follow the instructions below carefully and
always hold the oven door with both hands positioned away from
the door hinge area.
The door is heavy. For safe, temporary storage,
lay the door flat with the inside of the door facing down.
To remove oven door:
1.
Open oven door completely (horizontal with floor - See Fig.
1).
2.
Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven door
(See Fig. 2). A tool such as a small flat-blade screwdriver may
be required.
3.
Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - See Fig. 3).
4. Close the door to the broil stop position (the oven door will
stop into this position just before fully closing).
5.
With the oven door in the broil stop position, lift the oven
door hinge arms over the roller pins located on each side of
the oven frame (See Fig. 4).
To replace oven door:
1.
Firmly grasp both sides of oven door along the door sides (Do
not use the oven door handle - See Fig. 3).
2.
Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller pins
located on each side of the oven door frame (See Fig. 4). The
hook of the hinge arms must be fully seated onto the roller
pins.
3.
Fully open the oven door (horizontal with floor - See Fig. 1).
4. Push the door hinge locks up towards and into the oven frame
on both left and right oven door hinges (See Fig. 2) to the
locked position.
5.
Close the oven door.
Special door care instructions - Most oven doors contain glass
that can break. Read the following recommendations:
Do not close the oven door until all the oven racks are fully in
place.
Do not hit the glass with pots, pans, or any other object.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
time.
General Care & Cleaning
11
Fig. 1
Fig. 2
about
10°
oven
door
hinge
Fig. 3
roller
pin
hinge
arm
Fig. 4
Oven door
hinge
locations

Advertisement

Table of Contents
loading

This manual is also suitable for:

790. 9082790. 9080

Table of Contents