Whirlpool 6ED22DQXFW00 Service Manual page 4

WHIRLPOOL CONSUMER SERVICES
Models 6ED22DQXFW00 6ED22DQXFB01 6ED22DQXFW01
5. Disconnect the power wire harness connector (BL/BL and W wires).
6. Disconnect the flapper door heater wire harness connector (if connected).
7 Release the dispenser micro switch retainers and slide the switches off their locater pins. Carefully handle the
switches so they do not come apart.
8. Disconnect the wires from lampholder terminals.
9. Remove two 1/4" hex head screws from the control bracket and remove the control bracket.
10. Remove the 1/4" hex head screw securing the water fitting (spout) to the water dispenser lever. Remove the
water fitting.
11. Unsnap the ice guide and remove it from the ice dispenser lever.
Refer to Figure 3 for the following steps :
6ED22DQXFB02 6ED22DQXFW02
6ED22DQXFB03 6ED22DQXFW03
Figure 3
Page 4 of 36