General Information; Remote Control; Power Supply - Philips MC165 Manual

GENERAL INFORMATION

Supplied accessories
– 2 loudspeaker boxes
– 2 loudspeaker cables

– Remote control

– 2 batteries for the remote control
– AM/MW frame antenna
– FM wire antenna
– Mains lead
Safety information
Place the set on a solid surface. Make sure that there is
sufficient space around the set to prevent overheating.
Active mobile phones near to the CD-player may cause
malfunctions.
Maintenance
Do not expose the set, batteries
or CDs to humidity, rain, sand or
excessive heat (caused by heating
equipment or direct sunlight).
You can clean the set with a
soft, slightly dampened lint-free
cloth. Do not use any cleaning
agents as they may have a
corrosive effect.
This set complies with the radio interference
requirements of the European Community
6
REMOTE CONTROL
Batteries for the remote control
• Open the battery compartment of the remote control and
insert 2 batteries, type R03, UM-4 or AAA-cells
(preferably alkaline).
Remove batteries if they are flat or the set is not going to
be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Loudspeaker connections
The loudspeaker terminals are click-fit connectors. Use
them as shown below.
• Connect the unmarked wire to the red terminal and the
marked (black) to the black one.
1 2

POWER SUPPLY

A K E
S P E
–
R
L
R
O F E
W O
S U B
Mains
The type plate is located on the bottom of the set.
1 Check whether the mains voltage as shown on the type
plate corresponds to your local mains voltage. If it does
not, consult your dealer or service organisation.
2 Connect the mains cable to the AC MAINS inlet and the
wall socket. This switches on the mains supply.
To disconnect the set from the mains completely, remove
the mains plug from the wall socket.
For users in the U.K.: please follow the instructions
on page 2.
To avoid overheating of the set a safety circuit has
been built in. Therefore your set may disconnect
under extreme conditions. If this happens, switch
3
the set off and let it cool down before reusing it.
R S
+
R
A M
IA L
A E R
L
I N S
M A
A C