HP Elite x2 1012 G1 Quickspecs page 22

QuickSpecs
Technical Specifications
Wireless Serial Extension (WSE)
for support of USB data flow over
wireless link
Not all configuration components are available in all regions/countries.
c04895999 — DA – 15477 — Worldwide — Version 16 – March 22, 2017
DP & HDMI Color Depth
Support
Dual display mode
Multiple Display Stream
Support (MST)
Audio Pass-Through
Support
Independent Digital Audio
Out Interface (Sink)
Selection of Independent
Audio Out Interface
AUX/DDC Channel Interface
Chosen resolution, frame
rate, color space, audio
capabilities
Hot Plug
WGA WSE support
HP Elite x2 1012 G1
The following color depths are supported
8 bits per color
The Output interface (Display Port Multi-
Stream Transport, DP MST) has the ability
to support dual display mode – splitting
the video stream is based on external HW
(with monitors that can support it, a daisy
chain approach can be used to support
dual display mode)
The following dual display mode via MST
is supported

2 x (1280x720)

2 x (1920x1080)

2 x (1920x1200)
1920x1080 plus 1920x1200
Support for all relevant Audio formats in
Support for all relevant Audio formats in
Pass-Through mode as defined in the
WDE specification. LPCM (uncompressed
and uncompounded), 2-8 channels,
32KHz – 192KHz, up to 24 bits per sample
(dependent on the number of channels)
Support for an independent digital Audio
Out sink interface, operational upon
insertion of an audio peripheral, and not
dependent on monitor state
(On/Off/Powered-Off)

4 x I2S Interfaces

Multiplexed with

S/PDIF Interface
Selection of output interface (I
SPDIF) and on-board audio device
capabilities is configurable on a system
basis through module Flash
Configuration.
AUX (DP) / DDC (HDMI) channel is
supported.
Note: FAUX – fast AUX (~7000Mb) is not
required.
WDE will inform the host graphics of the
best resolution , frame rate, color space
and audio capabilities based on

Native/Supported monitor
resolutions

Module Core Capabilities

Power consumption considerations

Link status(physical layer rate and
other services)
Plug and Play through hot plug detection
is not supported
USB PAL (WSE) version 1.2 (June 2013)
2 S or
Page 22