Advertisement
IF THERE IS A LAMP IS INSTALLED IN THE FIXTURE:
1. RELEASE THE (4) FASTENERS LOCATED AT THE SMALL SIDES OF THE COWL. PULL FORWARD TO
REMOVE THE COWLING.
DO NOT PLACE ANY EXCESSIVE FORCE ON THE LAMP WHILE REPLACING THE PROTECTIVE WRAPPER!
2. WRAP THE BULB SECURELY IN THE PROTECTIVE WRAPPER THAT THE BULB WAS ORIGINALLY SHIPPED
WITH.
3. REMOVE THE (2) BRASS BOLTS CONNECTING THE SHORT LEADS TO THE FRONT BULB HOLDER USING A
7/16" WRENCH.
4. REMOVE THE CENTER MOUNTING SCREW, WASHER, AND SPRING (SEE FIGURE 4, ITEMS 2, 3, 4) FROM
THE SPIDER USING A 5/32" ALLEN WRENCH WHILE SUPPORTING THE FRONT BULB HOLDER SO THAT THE
BULB DOES NOT DROP WHEN THE MOUNTING SCREW IS REMOVED.
DO NOT EXERT EXCESSIVE FORCE ON THE BULB WHILE UNSCREWING IT FROM
THE REAR BULB HOLDER! THE BULB SHOULD RELEASE FROM THE REAR BULB
HOLDER WITH A VERY LIGHT COUNTERCLOCKWISE ROTATION. IF THIS DOES
NOT HAPPEN, SEE THE PROCEDURE FOR REMOVING A "FROZEN" BULB.
5. REMOVE THE BULB BY LIGHTLY PUSHING BACK ON THE BULB TO MOVE THE REAR BULB HOLDER TO ITS
REAR MOST POSITION WHILE LIGHTLY TURNING THE BULB IN A COUNTERCLOCKWISE ROTATION. THE
BULB WILL RELEASE FROM THE REAR BULB HOLDER IN APPROXIMATELY 1½ COMPLETE TURNS.
6. REMOVE THE BULB WITH THE FRONT BULB HOLDER ATTACHED FROM THE FIXTURE . PLACE IT ON A
STABLE WORKING SURFACE FOR THE REMOVAL OF THE FRONT BULB HOLDER.
7. TO REMOVE THE FRONT BULB HOLDER FROM THE BULB, REMOVE THE (2) CLAMP RETAINING SCREWS
LOCATED ON THE SIDE OF THE BULB SWIVEL HUB USING A 5/32" ALLEN WRENCH AND REMOVE THE
CLAMP.
8. REMOVE THE BULB HOLDER FROM THE BULB AND PLACE THE BULB INTO ITS SHIPPING CONTAINER FOR
SAFEKEEPING. RESECURE THE PROTECTIVE WRAPPER IF NECESSARY.
1. REPLACE THE FRONT BULB HOLDER RETAINING BOLT TO SUPPORT THE FRONT OF THE BULB WHILE
FREEING THE BULB FROM THE REAR BULB HOLDER.
DO EXERT ANY FORCE ON THE QUARTZ PORTIONS OF THE BULB
2. REACH THROUGH THE OPENING IN THE REAR OF THE REFLECTOR AND GRASP THE BULB'S END CAP
(THE REAR METAL FERRULE). WHILE LIGHTLY PUSHING THE BULB BACK INTO THE RECEIVER BLOCK,
TURN THE BULB IN A COUNTERCLOCKWISE DIRECTION UNTIL THE BULB BEGINS TO ROTATE FREELY.
6
DISASSEMBLY PROCEDURE
REMOVING A "FROZEN" BULB
WHILE ATTEMPTING TO FREE IT FROM THE REAR LAMP HOLDER!
CAUTION
WARNING
WARNING
Advertisement
