Troubleshooting - Philips MC-10 Owner's Manual

Troubleshooting

WARNING
Do not open the system as there is a risk of electric shock! Under no circumstances
should you try to repair the system yourself, as this will invalidate the warranty
¶ If a fault occurs, first check the points listed below before taking the system for repair.
¶ If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
Symptom
CD PLAYER OPERATION
"NO DISC" is displayed.
RADIO RECEPTION
Poor radio reception.
TAPE DECK OPERATION
Recording or playback cannot be
made.
GENERAL
Does not react when any buttons
is pressed.
No or poor sound.
Reversed left and right sound.
Remote control does not function properly.
Timer is not working.
20
pg 001-020/MC10/22-Eng
Remedy
¶ Check if the disc is inserted upside down.
¶ Wait until the moisture condensation at the lens
has cleared.
¶ Use a finalised CD-R(W).
¶ Replace or clean the disc, see Maintenance.
¶ The signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
¶ Increase the distance from TV or VCR.
¶ Clean deck parts, see Maintenance.
¶ Use only NORMAL (IEC I) tape for recording.
¶ Apply a piece of adhesive tape over the missing
tab space.
¶ Press STANDBY ON to switch off the system.
Remove the AC power plug from the wall
outlet, then reconnect the power plug and
switch on the system again.
¶ Adjust the volume.
¶ Disconnect the headphones.
¶ Check that the speakers are connected
correctly.
¶ Check if the stripped speaker wire is clamped.
¶ Check the speaker connections and location.
¶ Select the source (CD, TUNER, etc.)
before pressing the function button (É,í,ë,
etc.).
¶ Reduce the distance to the system.
¶ Insert the batteries with their polarities
(+/– signs) as indicated.
¶ Replace the batteries.
¶ Set the clock.
¶ Press TIMER ON•OFF to switch on the timer.
¶ If recording is in progress, stop recording.
20
3140 115 27752
12/7/00, 1:30 PM