VWR 97043-930 Instruction Manual page 23

Operating Your Cleaner with Ultrasonic, Heating & Degassing Feature
POWER
SONICS HEAT
ON/OFF ON/OFF
③

Change Set Temperature
Press MODE key till the number on the Temperature Display flashes (the shown
number at this point is set temperature). Press the Adjust key to change set
temperature and then turn on the HEAT key to start heating. The Heating Indicator
will flash and the number on Temperature Display will show bath temperature
(Temperature Display usually shows bath temperature and shows set temperature
only when adjusting set temperature).
POWER
SONICS HEAT
ON/OFF ON/OFF
③
When temperature of solution in the bath reaches set temperature, the machine will
stop heating. There will be 2 buzz as notification and the Heating Indicator will be on
but stop flashing. Press the Adjust key for over 2 seconds, the number on
Temperature Display will change rapidly.
 Set Degassing and Adjust Degassing Timing
Press MODE key till the Degassing indicator flashes. Press Adjust key
once (either up or down) to confirm degassing status. The Degassing Indicator will
be on and the Timing Display will show the 5-minute default degassing timing and
flash (users can then press Adjust key to select degassing timing within the range
of 1~99 minutes). Turn on the SONICS key to start degassing.
DEGAS
HEATING
MODE
min
℃
DEGAS
ENTER / ESC
①
②
DEGAS
HEATING
MODE
min
℃
DEGAS
ENTER / ESC
①
②
STEP:
① Press
MODE
on the timing screen flashes
② Press the
change timing
③ Press the
ultrasonic
STEP:
① Press
MODE
the temperature display flashes
② Press the
change set temperature
③ Press the
heating
21
key till number
key to
SONICS
key to start
ON/OFF
key till number on
key to
HEAT
key to start
ON/OFF
f