Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer - Chevrolet T-Series Owner's Manual

Turn and Lane-Change Signals

The turn signals are controlled by the
multifunction lever.
To signal a turn, move the lever all the way up for
right or down for left and release it. When the
turn is finished, the lever will return automatically.
To signal a lane change, raise or lower the
lever until the arrow on the instrument panel starts
to flash. Hold the lever in this position until the
lane change has been completed.
If you signal a turn or a lane change and the arrows
on the instrument panel turn on but do not flash,
check the turn signal flasher and circuit breaker.
88
An arrow on the
instrument panel
cluster will flash in the
direction of the turn
or lane change.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don't go on at all when
you signal a turn, check for burned-out bulbs and
a blown fuse. See Fuses and Circuit Breakers
on page 253.

Headlamp High/Low-Beam Changer

(Headlamp High/Low Beam Changer): To
3
change the headlamps from low to high beam,
push the multifunction lever toward the instrument
panel. To return to low-beam headlamps, pull
the multifunction lever toward you. Then release it.
While the high beams
are on, this indicator light
on the instrument panel
cluster will also be on.