Advertisement
The following procedure is for programming a RCG01A remote to your garage sectional door:
Caution: Do not touch any other buttons or components other than what is stated to do so in the below procedure.
1
Identify your receiver unit.
5
Press and release button 1
on your new remote once.
RCG01A
RCG01A
RCG01A - GARAGE & GATE
REMOTE PROGRAMMING
2
Unclip the light cover and
remove it.
6
If programming is successful,
the red LED will turn off.
Replace the cover and test
your newv remote at the unit to
confirm.
3
On the right side of the circuit
board locate the reciever board.
On the receiver board locate
the 'S1' or 'Learn' programming
button. It will be situated next to
a red LED.
4
Press and release the
'S1' or 'Learn' programming
button once, the red LED
should light up. You are now
in programming mode.
31A
Advertisement
