Independent RCG01A Manual

The following procedure is for programming a RCG01A remote to your garage roller door:
Caution: Do not touch any other buttons or components other than what is stated to do so in the below procedure.
1
Identify your receiver unit.
5
On the receiver board locate
the 'S1' or 'Learn' programming
button. It will be situated next to
the courtesy light globe and a
red LED.
RCG01A
RCG01A - GARAGE & GATE
REMOTE PROGRAMMING
2
Reach under the bottom to
release the locking clip.
6
Press and release the
'S1' or 'Learn' programming
button once, the red LED
should light up. You are now
in programming mode.
3
Lift the cover off to reveal the
internal circuit board.
7
Press and release button 1
on your new remote once.
4
Locate the receiver board on
the internal circuit board.
8
If programming is successful,
the red LED will turn off.
Replace the cover and test
your new remote at the unit to
confirm.
31A