Chicago Pneumatic CPPG2.3 Owner's Manual page 18

Clean the fuel valve lever sediment cup
Fuel valve
Sediment cup
Fuel filter
O-Ring
Sediment cup
Clean the spark plug
Recommended spark plug models F7RTC and F7TC
Spark plug
wrench
Spark plug cap
1 Remove the spark plug cap.
2 Clean the spark plug base.
3 Remove the spark plug with the spark plug socket spanner.
4 Inspect the spark plug insulator visually for damage. If it is damaged
replace a new one.
5 Measure the spark plug gap with a gap gauge. Twist the side electrode
to adjust the gap.The gap should be kept between 0 70 and 0 80mm.
6 Inspect if the washer of the spark plug is in good condition.
7 Reinstall the spark plug and tighten it with the spark plug socket spanner.
Press down the washer of the spark plug and place the spark plug cap.
30
Maintenance
Portable Gasoline Generator Operating Instructions
1. Close the fuel valve and remove
the sediment bowl. Take out the
-
O type seal ring and strainer.
2. Clean the sediment bowl, O
type seal ring and strainer with
-
incombustible or high flash
solvent.
-
3. Reinstall the O type seal ring
and strainer, and tighten the
.
sediment bowl
.
4 Open the fuel valve and inspect
for leakage.
:
0.70-0.80mm
. .
Valve clearance
(should be conducted by a professional person)
Figure 1 applicable to CPPG2.3 / CPPG2.5 / CPPG5 CPPG5T CPPG5.5.
-
Feeler gauge
Remove the cylinder head cover and measure the valve clearance with
,
the feeler gauge. The clearances are 0 1mm for the inlet valve and
.
0 15mm for the outlet valve.
Maintenance
Portable Gasoline Generator Operating Instructions
/
Figure 1
.
/
31