Table of Contents
Advertisement
On each of the nine points, you must adjust the extruder height to make sure that the table
and the extruder have a clearance of more or less 0.2mm.
You can see this points represented on the next picture.
Your printer should make a sound after finishing the leveling, if doesn't beep at the end of the
calibration you need to manually save the settings by goint to "Control" select "Store memory.
16
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DIY 3D PRINTER KIT and is the answer not in the manual?
Questions and answers