Table of Contents
Advertisement
EN 6
After unpacking the oven, make sure that it has not been damaged during transport and that the oven door
closes properly.
In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only
remove the oven from its polystyrene foam base at the time of installation.
Read all the safety recommendations at pages 2, 3, 4 before installing the appliance.
Follow the mounting instructions at page I and II when installing the appliance.
• Kitchen units in contact with the oven must be heat resistant (min 90°C).
• Carry out all cabinet cutting work and carefully remove all wood chips and sawdust before fitting the
oven in the housing.
• After installation, the bottom of the oven must no longer be accessible.
• For correct appliance operation, do not obstruct the minimum gap between the worktop and the
upper edge of the oven.
ELECTRICAL CONNECTION
Make sure the power voltage specified on the
appliance data plate is the same as the mains
voltage. The data plate is on the front edge of the
oven (visible when the door is open).
• Power cable replacement (type
H05 RR-F 3 x 1.5 mm
out by a qualified electrician.
Contact an authorised service centre.
The oven is programmed to operate with power
absorption above 2.5 kW (indicated by "16 A" in the
settings, as shown on page 10) which is
compatible with a domestic power supply above
3 kW.
If the household has a lower power supply, the
setting must be lowered ("13 A" in the settings).
INSTALLATION
PREPARING THE HOUSING UNIT
) must be carried
2
GENERAL RECOMMENDATIONS
Before use:
- Remove cardboard protection pieces,
protective film and adhesive labels from
accessories.
- Remove the accessories from the oven and heat
it at 200° C for about an hour to eliminate the
smell and fumes from the insulating materials
and protective grease.
During use:
- Do not place heavy objects on the door as they
could damage it.
- Do not cling to the door or hang anything from
the handle.
- Do not cover the inside of the oven with
aluminium foil.
- Never pour water into the inside of a hot oven;
this could damage the enamel coating.
- Never drag pots or pans across the bottom of
the oven as this could damage the enamel
coating.
- Make sure that the electrical cables of other
appliances do not touch hot parts of the oven or
become trapped in the door.
- Do not expose the oven to atmospheric agents.
BEFORE USE
Advertisement
Table of Contents
