Troubleshooting - Electrolux EWIE08F3MMW Instruction Manual

39 electrolux troubleshooting

Troubleshooting

When the washer is in trouble, please contact authorized service centre.
Do not dismantle the washer without permission.
Before calling, please check out the list as follows.
PROBLEM INSPECTION ITEMS
No water If the power is off or the fuse is burned out.
flows in If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic sound is normal
phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power switch is pressed.
If the power is off or the fuse is burned out.
No
If the power supply voltage is too low.
washing
If the water amount reaches to the required water level.
(The washer will not work if the water amount does not reach the required water
level)
If it is set to "Delay" washing mode. (It will only start to work until the reservation
time reached)
Abnormal If the water drain hose is placed very high.
draining If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
Abnormal
If all clothing piled largely at one side of barrel or the clothing is excessively
spin
placed.
If the washer is not placed in stable condition or it is placed in inclination state.
(The ground is not flat).
If the motor belt is loosened.
• During the spin process, if clothing is piled at one side of the spin barrel, it will
cause unbalance of spin barrel. At this moment, the computer inside the
washer will feel this unbalance phenomenon and will automatically correct it (
fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can
not resolve the problem. Then the user has to manually and evenly place the
clothing inside the barrel to solve the problem.
Malfunction display and solutions
Fault Cause of fault Indication
Water injection for
Alarm for
about 30 mins, but
water inlet
do not reach preset
water level.
Drain off water 6
Drain Alarm
mins not arrive at
empty water level.
Alarm for Open the lid during
opening lid washing or spinning
process
Checked unbalance
Unbalance
for the third time.
Alarm
troubleshooting electrolux 40
Alarm of the
Stopping alarm
buzzing sound
The buzzer goes Open the lid to
E1 on buzzing for 10 deal with faults,
seconds. If the then close the
fault is not lid to stop the
solved, alarm.
buzzes again for
10 seconds in
every 15minutes.
E2
E3
E4