Millimar C 1208 Operating Instructions Manual page 3

Dear valued customer,
Congratulations on choosing a product by Mahr
GmbH. We kindly request that you follow the
instructions below in order to ensure the long-
term precision of your measuring instrument.
We operate a policy of continuous improve-
ment and are constantly developing our prod-
ucts, especially with regard to renaming of type
designations. It is possible therefore that there
may be slight differences between the text and
illustrations in this document and the measuring
instrument in your possession. We reserve the
right to make changes to the design and scope
of supply, the right to undertake further technical
developments, and all rights relating to transla-
tion of this documentation.
© by Mahr GmbH, Standort Esslingen
These Operating Instructions contain the following symbols:
General information.
Important information. Non-observance of this information can result in incorrect meas-
urements or even damage to the instruments!
Mahr GmbH, Millimar C1208/C1216/C1240
Permitted Uses
The Millimar C 1208/C 1216/C 1240 is an elec-
tronic length measuring and evaluating instru-
ment for use in a production environment.
Permitted use is subject to compliance with all
published information relating to this product.
Any other use is not in accordance with the per-
mitted use. The manufacturer accepts no liability
for damages resulting from improper use. All
statutory and other regulations and guidelines
applicable to the area of use must be observed.
There are 3 different versions available:
C 1208/C 1216 M, T, F:
One or two inductive probes can be connected.
C 1208 PE:
a pneumatic sensor (air plug gage, air ring gage)
can be connected.
C 1240 M:
One or two Mahr compatible inductive
probes (including the probe type 1340,
which up to now could only be used
in conjunction with the evaluation unit
Millimar 1240) can be connected.
The operating, maintenance and repair in-
formation specified in these operating in-
structions and the operating instructions for
the measuring station components must
be observed.
1