Philips DCB293 User Manual page 14

2
Press / to scroll the menu options:
[Station list]
[Full scan]
[Manual tune]
[DRC] (dynamic range control)
[Prune]
[System]
3
To select an option, press ENTER.
4
Repeat step 2-3 if sub-option is available
under one option.
Full scan
Full scan is used to perform a wide range of
DAB+ radio search.
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [Full scan] is
displayed.
3
Press ENTER
»
Full scan starts automatically.
Manual tune
channel/frequency manually. In addition to
antenna orientation for better radio reception,
the optimal reception can also be obtained
with this feature.
1
In the DAB+ mode, press MENU to
display the "Manual tune" option.
2
Press ENTER
»
The display shows a channel and its
frequency.
3
Press / repeatedly until the desired
channel/frequency appears.
4
Press ENTER
Tip
You may press DISPLAY to change the service
information on the display.
You may adjust the position of the antenna to
obtain the optimal signal strength.
Press MENU to exit manual tune
function.
DRC
Dynamic range control (DRC) adds or
removes a degree of compensation for the
differences in the dynamic range between
radio stations.
[DRC off] (DRC is switched off.)
[DRC high] (DRC is switched on;
the default setting recommended for
noisy environment.)
[DRC low] (DRC is set to half
normal level)
Prune
With this feature, you can clear all the invalid
stations from the station list.
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [Prune] is
displayed.
3
Press ENTER
» [Y] or [N] is displayed.
4
Press / to switch between [Y] and
[N].
5
Press ENTER
System
With this feature, you can:
know the software version of the unit
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [System] is
displayed.
3
Press ENTER
» [SW version] is displayed.
4
Press ENTER again.
»
The software version of the main unit
is displayed.
reset DAB/FM stations
1
In the DAB+ mode, press MENU to
enter the menu options.
2
Press / repeatedly until [System] is
displayed.
3
Press ENTER
» [SW version] is displayed.
EN 15