Peak PKC0RA Installation Manual

Wireless Back-Up Camera and Monitor
Dear Customer,
CONGRATULATIONS. The PKC0RA Wireless Back-up Camera and Monitor, when used as
described, it will improve your ability to see behind your car, truck, RV, or mini-van. We have
taken numerous measures in quality control to ensure that your product arrives in top
condition, and will perform to your satisfaction.

Before You Install

Automotive video equipment installations can be difficult at times, even to the most
experienced of installation technicians. If you are not confident working with 12 volt DC
vehicle wiring, removing and reinstalling interior panels, carpeting, dashboards or other
components of your vehicle, contact the vehicle's manufacturer, or consider having the
PKC0RA professionally installed.
This device, as well as all other wireless devices, may be subject to
interference. Interference may be caused by cell phones, Bluetooth
headsets, Wi-FI routers, power lines and other various electrical equipment,
etc.

Parts

1. Monitor and mounting Arm
3. Transmitter Box
Model No.: PKC0RA
2. Camera
4. Camera Mounting Accessories
4. Monitor Power Cable
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

Installation

These instructions do not apply to all vehicles. They are only meant as a general guide
due to the number of different makes & models.
For vehicle specific questions contact your vehicle's manufacturer.

MONITOR INSTALLATION

When choosing a location to mount the monitor, make sure the monitor is in an area that will
not obstruct your vision while driving.

Choose a Location and Install Power Cable

1. Temporarily place the monitor in the location that you have chosen
2. Route the power cable to the vehicle's cigarette lighter socket/12V
power outlet. The cable must not interfere with the safe operation of
the vehicle.

Mounting the Monitor

Before mounting the monitor, clean the mounting surface well.
1. Position the suction cap mount to the smooth surface which suits
your requirement.
2. Press the suction cap against the smooth surface such as
windshield or dashboard.
3. Press the lock down to attach and fix the mount to the surface.
4. Snap in the monitor to the suction cap mount.
5. Adjust the mounting arms to suit your view angle to the monitor.
5. Transmitter Box Power Cable