Related Manuals for Winco 6980-6988
Summary of Contents for Winco 6980-6988
- Page 1 OWNER’S OPERATING & MAINTENANCE MANUAL For Models: 6980-6988 & 6990-6998 PLEASE DO NOT DISCARD THIS MANUAL! KEEP FOR FUTURE REFERENCE AND TRAINING...
-
Page 2: Table Of Contents
WITHOUT NOTICE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE! NO PART OF THIS MANUAL MAY BE DUPLICATED IN ANY FORM WITHOUT THE PRIOR CONSENT OF WINCO MFG, LLC. UNAUTHORIZED DUPLICATION MAY RESULT IN CIVIL PROSECUTION TO THE MAXIMUM EXTENT ALLOWED BY LAW. -
Page 3: Important Safety Information
4. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the product to an authorized Winco service center. 5. DO NOT carry or pull this product by power supply cord or use the cord as a handle. - Page 4 No adapter should be used with this product. For an added level of safety; Winco recommends the use of a 120 volt GFCI (ground fault circuit interruptor) outlet.
-
Page 5: Assembly Instructions
ASSEMBLY INSTRUCTIONS BACK ASSEMBLY INSTRUCTIONS 1. Carefully remove back assembly and chair frame from carton. Note: Handle with care when removing chair from box. This will ensure that no damage is done to the cables and/or wiring that connects the back to the chair. 2. -
Page 6: Operating Instructions
OPERATING INSTRUCTIONS RECLINING THE CARE CLINER & TRENDELENBURG (Figures 3 & 4-1 are attendant operated ONLY) 1. LEGREST ELEVATION: From the "SEATED UPRIGHT" position, grip the Legrest Handle and pull towards the back of the chair until handle stops (FIG.1). 2. - Page 7 OPERATING INSTRUCTIONS (cont'd) LOCK/ UNLOCK CASTERS (Total-Lock vs. Directional) 1. Total-Lock casters will lock wheel and swivel mechanism by using your foot & pushing down on the tab. Both front and the right-rear casters are Total-Locks. These are identified with lighter gray tabs. Directional caster is used to help steer the chair (Left rear FIG.
-
Page 8: Operating Instructions
AND connection of power cord to power pack unit under chair. • If switch displays a flashing light; Check all accessible wire connectors under chair for possible loose connections, then contact Winco customer service: 1-800-237-3377. CORD STORAGE (Models with Heat-HT or Heat & Massage-HM) 1. -
Page 9: General Maintenance
GENERAL MAINTENANCE ADJUSTING GAS SPRING NOTE: Tension or "ease of movement" of the gas spring is set by factory and cannot be changed. Using 2 people (RECOMMENDED), tilt the chair over onto the Left side and locate the Gas Spring (FIG. 1). Loosen the 11/16" hex nut on the Gas Spring located near the bottom-front of the chair. -
Page 10: Specifications
6980 & 6990 SPECIFICATIONS 6980 - Specifications Seat Height ......23.5" Back Height Above Seat..32.5" to Footrest Plate...16.5" Seat Depth......21.5" Seat Width.......21" Weight .........167 lbs. Overall Height ......52.5" Overall Width (Trays Down)...34.5" (Trays Up)..44" Maximum Weight Capacity..350 lbs. 6990 - Specifications Seat Height ......23.5"... -
Page 11: Nocturnal Care Cliner Options
NOCTURNAL CARE CLINER OPTIONS Heat & Massage IV Pole & Attachment Oxygen Tank Holder HM ........Heat & Massage IV........ IV Pole & Attachment O2........Oxygen Tank Holder HT ..........Heat ONLY FACTORY INSTALLED ONLY Armrest Covers Side Cushion AC00......Armrest Covers (Pair) SC00..........Side Cushion... -
Page 12: Limited Warranty
Winco Mfg., LLC. sole discretion, it may repair or replace any components freight free that are found to be defective during the fi rst year. Winco Mfg., LLC. shall not be liable for any labor, or any other costs incurred as a result of or in conjunction with a warranty claim.
Need help?
Do you have a question about the 6980-6988 and is the answer not in the manual?
Questions and answers