Present System Status (H4); Sub Menu List (U1 - U8) - Panasonic EBL128 Daily User's Manual

9. PRESENT SYSTEM STATUS (H4)

Information only.
a) Log on to the c.i.e.
b) Navigate to menu H4.
c) Press "A". The sub menu consists of a list (U1 - U8) in which you can scroll. U1 is displayed.
d) Select a sub menu and press "A".
9.1. SUB MENU LIST (U1 – U8)
U1 Disablement
U2 Disablement by time channel
U3 Sensor values
Sensors activating service
U4
signal
U5 Technical warning
U6 Event log
U7 Version and alarm counter
DAILY USER´S MANUAL
Disablements, except "disablements by time channel", are
displayed.
Indicated by LED "Disablements".
Only "disablements by time channel", are displayed.
Indicated by LED "Disablements", also the LEDs "Fault /
Disablements Alarm devices" and/or "Fire brigade tx".
Use the keypad to specify the "Start sensor".
The default zone-address 00-00 can be used.
Press "A". This is a list in which you can scroll.
NOTE! For most detectors additional information can be shown by
using .
Indicated by LED "Service".
NOTE! Service signal is acknowledged via menu H8/S2, which
require log on with a password for access level "Service
personnel".
If one or more technical warnings are activated in the system, the
technical warning symbol [i] is shown.
Use the keypad to select event log:
- 0 = Alarm.
- 1 = Interlocking.
- 2 = General.
Press "A". This is a list in which you can scroll.
- Version: The EBL128 software / firmware version.
- Alarm counter The alarm counter is increased with "1" every time
the c.i.e. enters the real "fire alarm condition".
13
• •
EBL128 VERSION 2.2.X DOCUMENT NUMBER: MEW01786
•
REVISION: 1