Load-Balance Policy - Draytek VIGORIPPBX 3510 SERIES User Manual

PPP Authentication
Index (1-15)
4 . 2 . 5 L o a d - B a l
4 . 2 . 5 L o a d - B a l
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are activated.
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
VigorIPPBX 3510 Series User's Guide
Choose PAP or CHAP /PAP Only for authentication in PPP
connection.
Set the PCs on LAN to work at certain time interval only. You may
choose up to 4 schedules out of the 15 schedules pre-defined in
Applications >> Schedule setup. The default setting of this filed is
blank and the function will always work.
a n c e P o l i c y
a n c e P o l i c y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
126