Advertisement
Charge Mode
A
1.MAIN MENU -> press the
2.Set the current rate before charging. Adjustable charge rates from 300mA-5000mA.
B
The default current is 2A, you can use the +(INCREASE) and -(DECREASE) button
to adjust the charge rate.
C
See the table below to select the charge rate for Ni-Cd & Ni-MH battery packs. We
recommend that you charge 1800mAh receiver packs at 1.8 amp. (1C).
Battery Capacity
600mAH
1300mAH
3300mAH
It's normal situation if the current value of Ni-Cd & Ni-MH turn to zero after period
D
of charging.
E
An exhausted Li-Po battery pack can be fully recharged in approximately 2-3 hours
with charge rate at 1C.
F
To Re-peak the pack, simply press the S(START) button.
G
Press the
H
The cooling fan will work when you press the S(START) button to start charging.
Discharge Mode
A
1.MAIN MENU -> press the
discharge mode.
2.The discharge rate is 0.3A~2.0A (Adjustable).
B
It's necessary to set discharge bottom voltage of Ni-Cd & Ni-MH, single cell can't
lower than 0.8V,
6cells can't lower than 4.8V.
C
END DISCHARGE
1.To Re-Discharge the pack simply press the S(START) button.
2.Press the
Cycle Charge Mode (Discharge
MAIN MENU -> press the
A
twice into charge after discharge mode, and then press the S(START) button
to start.
Before you get into this mode, you have to set the charge / discharge rate and the
B
discharge voltage.
Charge Rate
0.6A
1A
2A
5A
(ENTER) button to show MAX. voltage.
(ENTER) and then the +(INCREASE) button into
(ENTER) button to return MAIN MENU.
(ENTER) and then the +(INCREASE) button
(ENTER) into charge mode.
Charge Time
60 ~ 80 Min.
78 ~ 94 Min.
54 ~ 65 Min.
40 ~ 48 Min.
2
Charge)
Advertisement
