Download Print this page

Remote Control; Volume Control; Selecting Tracks - Box-Design DS2T Instructions For Use Manual

Cd box

Mains power connection and methods to switch the unit on and off

Connect the low voltage plug from the power supply to the Power 9V socket of the unit before connecting

the power supply to the mains. The unit can be switched on and off by using 2 different methods which are

equal in priorities.

1. Using front pushbutton to switch on or into standby

The pushbutton on the front panel of the unit alternately turns the power on or returns it to standby mode. The

blue LED on the front panel shows that the unit is powered on. If a trigger signal is present the unit can't be

switched off by the pushbutton.

2. Remote power on - triggers

The unit can be switched on via other Box Design components when a 12V trigger voltage is present at the

2.5mm socket marked Trigger Input. Special power-on cables (polarity

available as accessories. The remote power-on signal can be relayed to further units via the Trigger Output

socket. When the 12V trigger signal is switched off, the unit will also switch off.

Trigger cables may only be plugged into the sockets when the unit is disconnected from the power

supply and from the mains. Failure to do so may result in damage of the unit.

Remote control

+10

and

For example, to play track 19, press

To play track 29, press

ON/OFF

turns the unit on or back into standby

VOL

adjust the sound volume of your Pro-Ject Audio amplifier

(Excluding Pre box RS Digital, Maia DS(2), Pre Box DS2 Digital, Pre Box DS2

Analogue)

Stop

STOP

stops playback

Start / Pause

starts and pauses playback alternately

accesses a specific track directly and start playback.

+10

and

+10

and

) in diverse lengths are

Table of Contents