Advertisement
Getting Started
Powering up
To turn the Home Gateway on or off, press the On/Off button on its side.
After you turn the Home Gateway on, the WAN indicator light will blink, indicating
that the Home Gateway is connecting to the iiNet network. Once connected, the
WAN indicator light will stop blinking and remain on.
Getting Online
Before attempting the steps below, please plug your desktop or laptop computer
directly into the modem via an Ethernet cable.
1.
Open a web browser on your computer. Type http:/ /192.168.1.1 into the
address box, and then press Enter.
2.
Log in to the Home Gateway's Settings page with these default details:
Username: admin
Password: admin
3.
You'll see the Wizard page. Click Next.
6
4.
Enter your VDSL Username and Password (case sensitive) as supplied by
your Internet Service Provider, and then click Next.
5.
You can choose to keep the default WiFi details as found on the back of your
Home Gateway, or customise them here.
SSID: WiFi network name
WPA pre-shared key: WiFi password
We recommend writing these details down - you'll need them to connect
devices to your home WiFi network.
6.
Click Next and confirm all the settings are correct before hitting Submit.
You should now be able to get online with any computers connected to the
yellow LAN ports with an Ethernet cable. You can also connect devices to Home
Gateway's wireless network (WiFi).
•
If you're not sure how to connect a device to the WiFi, see the advice on page 8.
•
If you have a Netphone (VoIP) service, you can configure it by following the
instructions on page 9.
7
Advertisement
Need help?
Do you have a question about the Home Gateway and is the answer not in the manual?