Table Of Contents - Kenwood RXD-M65V-H Service Manual

RXD-M65V-H/M65V-N
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES .................................. 2
EXTERNAL VIEW .......................................................3
DISASSEMBLY FOR REPAIR....................................4
BLOCK DIAGRAM ......................................................5
CIRCUIT DESCRIPTION ............................................6
ADJUSTMENT ..........................................................13
Accessories
AM Loop antenna (1)
(T90-0852-05): V
(T90-0893-05): MM1XE
Batteries (R6/AA) (2)
SYSTEM CONFIGURATIONS
SYSTEM MAIN UNIT
HM-V655MP-H RXD-M65V-H
HM-V655MP-N RXD-M65V-N
Cautions
Operation to reset
The microcomputer may fall into malfunction (impossibil-
ity to operate, erroneous display, etc.) when the power
cord is unplugged while unit is ON or due to an external
factor. In this case, execute the following procedure to
reset the microcomputer and return it to normal condi-
tion.
÷ Please note that resetting the microcomputer clears
the contents stored in and it returns to condition
when it left the factory.
The marking of products using lasers
LASER PRODUCT
The marking of this product has been classified as Class 1. It means
that there is no danger of hazardous radiation outside the product.
Location: Back panel
2
Remote control unit (1)
(A70-1587-05): MM1XV
(A70-1588-05): E
FM indoor antenna (1)
(T90-0855-05): V
(T90-0877-05): MM1XE
DESTINATION
EMX
V
CLASS 1
INTERCONNECTION DIAGRAM .............................15
PC BOARD .............................................................. 16
SCHEMATIC DIAGRAM .......................................... 21
EXPLODED VIEW ....................................................28
PARTS LIST..............................................................30
SPECIFICATIONS ....................................................36
AC Plug Adaptor (1)
(E03-0115-05)
SPEAKER
LS-M65V-H
LS-M65V-N
Unplug the power cord from the power outlet, then while
holding the POWER or
cord again.
standby/timer
After resetting the microcomputer, the display will show
as follow:
(For countries other than U.S.A., U.S.-Military and Canada)
Inside this laser product, a laser diode classified as Class 3A laser
radiation is contained as alerted by the internal caution label shown
above. Do not stare into beam or view directly with optical instruments.
Location: CD laser pick-up unit cover inside this product
Use to adapt the plug on the
power cord to the shape of the
wall outlet.
(Accessory only for regions where
use is necessary.)
key depressed, plug the power
POWER
or
standby/timer
CAUTION
VISIBLE LASER RADIATION
WHEN OPEN. DO NOT STARE
INTO BEAM OR VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS.