Table of Contents
Advertisement
D
C
ISH
Use this function to identify the type of satellite
antenna dish.
At the Installation menu, select Dish
Configuration by using the
highlight this option. Press OK.
Use the
and
you have.
Press BACK to return to the Installation menu.
P
OINT
Use this function to manually point the dish to
determine that it is correctly aligned with the
satellite(s). Refer to the separate satellite dish
Installation Guide for instructions on how to
physically adjust the satellite dish angles. You may
want to have a helper to read the onscreen dis-
plays during this procedure. Signal strength read-
ings change approximately 2 seconds after the
adjustment is made. Note that single dish installa-
tions often show higher signal strength than
installations which receive signals from two or
three satellites. The onscreen display will tell you
how to align your dish based on your zip code.
At the Installation menu, select Point Dish by
using the
buttons to highlight this option.
Press OK.
The on screen displays a signal strength meter.
Adjust the dish until the signal strength meter
stabilizes at a maximum reading. The range is 0 to
100. It is recommended to obtain a signal
strength of at least 60. Refer to step 11 of the
Antenna Assembly & Alignment Guide (page 10).
Press BACK to return to the installation menu.
NOTE:
Use the
or
buttons to switch between
satellites. Use the
between transponders for the selected satellite.
Next, go to System Test on page 21.
O
S
N
CREEN
ONFIGURATION
buttons to
buttons to highlight the dish
D
ISH
or
buttons to switch
I
NSTALLATION
Please choose the option that best matches your setup.
20
(C
'
)
ONT
D
Advertisement
Table of Contents
