CONNECTIONS
The following connections are located on the back of the unit:
1
1 - 230 V/50 Hz:
2 - AUDIO TV L & R: Audio output, left and right-hand channel for connecting to a stereo unit.
3 - TV:
4 - VCR:
5 - DATA INTERFACE: RS 232 interface for serial data transfer during servicing.
6 - SAT-IF INPUT:
7 - SAT-IF OUTPUT:
Note:
4
2
Connect the power cable to the power socket.
Connect the TV connection socket to your television unit using the
SCART cable supplied.
VCR SCART socket for connecting a video recorder.
0-modem cable (pins 2 and 3 crossed, pins 1, 4, 6-9 are not used).
Receiver:
Pin 2 = RXD
Pin 3 = TXD
Pin 5 = GND
Sat-IF signal input and output for LNB supply and control signals
connect the cable of your satellite unit to this socket.
IF signal output (e.g. for feeding through an analogue receiver).
The label showing the type and serial number is underneath your receiver.
3
4
5
PC:
Pin 2 = RXD
Pin 3 = TXD
Pin 5 = GND
6
7