Jet JCT-1600 Operations & Parts Manual page 3

20. Do not use power tools in damp or wet
location, or expose them to rain. Keep work
area well lighted.
21. Do not leave a connected tool unattended.
When not in use, disconnect tool from air
source.
22. Shut off air supply and discharge any residual
pressure from tool before removing hose,
making adjustments, changing accessories,
or storing tool.
23. Make sure tool is switched off, and your finger
off the trigger, before connecting to air supply.
24. Remove adjusting keys and wrenches before
turning on tool.
25. Keep visitors a safe distance from the work
area. Keep children away.
26. Give your work undivided attention. Looking
around, carrying on a conversation and
"horse-play" are careless acts that can result
in serious injury.
27. Do not force a tool or attachment to do a job
for which it was not designed. The right tool
will do the job better and more safely.
28. Repetitive motions
constant vibration can be harmful to hands
and arms. Take frequent breaks and relax
hands during extended operation. Change
posture to avoid discomfort or fatigue.
29. Compressed air can be harmful if directed
toward sensitive areas of the body, and may
propel small particles caught in the air stream.
Exercise proper caution.
30. Use only recommended
improper accessories may be hazardous.
31. Maintain tools with care. Keep air tool clean
and oiled for best and safest performance.
32. Do not use combustible gases, carbon
dioxide, oxygen or any bottled gas as an air
source for the tool. These can present risk of
explosion and serious injury.
33. Do not lubricate the tool with combustible
liquids, such as kerosene, diesel or jet fuel.
34. Do not dispose of this tool with normal
household waste. Never dispose of the air tool
into fire.
and/or exposure
accessories;
Specific warnings for Sand Rammers
35. This sand rammer is designed and intended
for use by properly trained and experienced
personnel only. If you are not familiar with the
proper and safe operation of a pneumatic
sand rammer, do not use until proper training
and knowledge have been obtained.
36. Make sure butt is securely mounted on piston
before operating. Do not point butt end of tool
toward yourself or others.
37. Keep your feet away from the butt.
38. Keep hands away from throttle lever until you
are ready to operate tool.
39. Avoid using rammer in horizontal position.
40. Avoid contacting solid materials with the butt,
such as concrete or granite.
41. Normal operation of this sand rammer may
expose operator to high levels of vibration.
This can be mitigated somewhat by the
following means:
•
Grip tool firmly enough to safely control
it, but do not over-grip or exert
unnecessary force – allow tool to do its
to
job.
•
Maintain a comfortable stance, yet firmly
balanced with feet shoulder-width apart.
•
Change posture slightly and/or switch
hand positions during extended work.
•
Do not exert pressure from other parts of
your body on the tool; only your hands
should contact it during operation.
•
Avoid placing your hands against ridges
or protuberances on the tool that can
constantly rub or strike your hands. Wear
padded gloves.
•
Use recommended air pressure; higher
or lower pressure may result in increased
vibration.
•
Use common sense: Avoid prolonged
use of the sand rammer, and take breaks
when needed, especially if symptoms of
fatigue,
discomfort appear. If symptoms persist,
you may wish to consult a health
professional.
numbness or excessive
JET 3