Table of Contents
Advertisement
2.4 Programming Four-digit Entry Codes
Four-digit entry codes are entered on the Keypad preceded by " # " to allow the RESIDENT ACCESS.
DO NOT confuse a FOUR-digit ENTRY code with a FIVE-digit ENTRY code (see section 2.8).
1. Press
2. Choose and enter a four-digit entry code, then press
3. Repeat step 2 to enter additional four-digit entry codes one at a time.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.5 Erase a Four-digit Entry Code
CAUTION: This programming sequence will delete an INDIVIDUAL four-digit entry code that has been previously
programmed in. This cannot be UNDONE.
1. Press
2. Enter an existing four-digit entry code to be erased, then press
3. Repeat step 2 to erase additional existing four-digit entry codes one at a time.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.6 Erase ALL Four-digit Entry Codes
CAUTION: This programming sequence will delete ALL four-digit entry codes that have been previously programmed in.
This cannot be UNDONE.
1. Press
2. Enter 9 9 9 9, then press
3. A long beep after approximately 10 seconds indicates that all four-digit entry codes are
2.7 Four-digit Entry Code Divide Number
The four-digit entry codes can be made to activate either Relay 1 or Relay 2 by programming a four-digit "divide" number.
Four-digit entry codes EQUAL TO or LESS THAN the divide number will activate Relay 1, while four-digit entry codes GREATER
THAN the divide number will activate Relay 2. If NO divide number is programmed (enter # # # # in step 2), then Relay 2 acts as
an alarm by-pass relay, activating .1 second PRIOR to Relay 1, and deactivating .1 second AFTER Relay 1.
Important:
Both four-digit and five-digit entry codes must be programmed to operate in the same mode. If a divide number is
programmed for the four-digit codes, then a divide number MUST also be programmed for the five-digit entry codes (see section
2.11).
Factory setting is NO divide numbers programmed (# # # #).
1. Press
2. Choose and enter a four-digit divide number, then press
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
Note: To delete an existing four-digit entry code divide number, enter # # # # in step 2. This will cause relay 2 to act as an alarm
by-pass relay provided that the existing five-digit divide number has also been deleted (see section 2.11).
10
0 2 and enter the MASTER CODE. [
*
0 8 and enter the MASTER CODE. [
*
0 0 and enter the MASTER CODE. [
*
*
deleted and programming ends.
1 2 and enter the MASTER CODE. [
*
0 2 _ _ _ _ (beep)]
*
*
0 8 _ _ _ _ (beep)]
*
0 0 _ _ _ _ (beep)]
*
. [ 9 9 9 9
(beep)]
*
1 2 _ _ _ _ (beep)]
*
. [ _ _ _ _
(beep)]
*
. [ _ _ _ _
(beep)]
*
*
. [ _ _ _ _
(beep)]
*
*
1506-065-K-6-17
Hide quick links:
Advertisement
Table of Contents
