Create 3400 Quick Start Manual
  1. Manuals
  2. Brands
  3. Create Manuals
  4. 3D Printers
  5. 3400
  6. Quick start manual
Create 3400 Quick Start Manual

Create 3400 Quick Start Manual

Hide thumbs Also See for 3400:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

See also: Handbook
Create 3400™
3D Printer
Quick Start Guide
www.CreateOandP.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 3400 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Create 3400

Summary of Contents for Create 3400

  • Page 1 Create 3400™ 3D Printer Quick Start Guide www.CreateOandP.com...

  • Page 2: Included In The Box

    Included in the box: Printer (shown above) with:  Glass with protective foam  Nozzle cleaning needles  Extruder purge (cleaning filament)  Extra Teflon tube  Tweezers  Build plate clips  Power cable  Hex wrenches  Spade ...

  • Page 3: Hardware Installation

    Hardware Installation Cut the zip ties that are securing the clips in place. Remove the clips holding the extruder assembly in place before powering on your printer. If you fail to remove these clips your printer will be damaged. Please save these clips and re-install them if you transport your printer.
  • Page 4 Hardware Installation (continued) Plug in the power plug. Install the filament holder in the mounting hole on the side of the printer and place a spool of PLA filament on the holder. Feed the filament up through the guide tube. Insert the filament into the right nozzle, and push it in until the feeding gear bites into it.
  • Page 5 Hardware Installation (continued) Remove the glass build plate from the protective foam. Gently slide the glass plate onto the build plate. Make sure it snaps into the build plate clamps at the back. Use the remaining build clips to secure the glass build plate to the heated build plate.

  • Page 6: Install Software

    STOP HERE! Please call or email the Create office to schedule your initial set-up call with our Printer Education Specialist before continuing. We will walk you through setting up and printing your first items, as well as the basic hardware and controls on your printer.
  • Page 7 “Load.” Follow the instructions on the screen to finish loading the filament. NOTE: Create printers are set up to print Flexy (flexible) filament on the left side, and all rigid filaments on the right side. Although your printer has been pre-leveled, it’s a good idea to check the level in case it shifted during shipping.
  • Page 8 Start your first print (continued) The preferred distance between the nozzle and the platform is around 0.15-0.2mm, but please refer to the instructions given to you in your initial-set up phone call as this height can vary slightly, depending on what you are printing. The distance between the nozzle and the platform can be adjusted by turning the thumb screw on the left front corner of the Z plate.

  • Page 9: User Interface

    User Interface WWW.CREATEOANDP.COM...

Table of Contents