Advertisement
Starting Unisen's iPazzPort
Starting up this hardware and application is simple.
1. Plug the USB adaptor into any available USB port.
2. Power on the iPazzPort by moving the slide switch as shown by arrow 8.
3. Wait 30 seconds. Three LEDs will light up and then go out, this is normal.
When you touch the Mouse Touch Pad or press any keys LED 3 will flash
indicating proper operation of the unit and transmission between the USB
adaptor and the iPazzPort. The USB adaptor will also flash about every
second.
A. If you find that LED 3 is blinking rapidly please check the following
two items:
1. Check your distance between the Keyboard and the computer.
Is it within 30'?
2. Check to see if you have plugged in the USB adaptor to your
computer correctly.
4. The iPazzPort has a battery saving feature. This feature puts the device
into sleep mode if you do not use it after 3 minutes. LED 3 & 5 will blink
continuously. You can wake up the unit by pressing any key for one second.
5. Arrow 10 points to the Input Switch Key
When this key is pressed LED 5 will light up. This LED will stay on until this key
is pressed again. That means while this light is on any key you press will use its
secondary input rather than its primary input. For example the key B is normally
B or b, but when you press the SF key it becomes the number 0. When you
have selected the Input Switch Key LED 5 will light up. When you are in normal
mode LED 5 will be turned off.
Advertisement
