Advertisement
HOW TO CONNECT THE GPS ANTENNA
ONCE YOU HAVE CHOSEN THE POSITION FOR THE ANTENNA,
MAKE SURE THAT THE RECEPTION IS GOOD BEFORE FIXING
IT IN PLACE:
- DRIVE THE VEHICLE TO AN OPEN SPACE, WELL AWAY
FROM BUILDINGS OF A CERTAIN HEIGHT
- CONNECT THE SAT PROGRAMMER AND TEST TO MAKE
SURE THAT EVERYTHING WORKS PROPERLY BY MEANS
OF THE APPROPRIATE FUNCTION (CONSULT THE RELATIVE
MANUAL).
This device complies with Part 15 of the FCC rules subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept all interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
OK
CAREFULLY
CLEAN THE
GPS
FIXING
ANTENNA
SURFACE
Meta System S.p.A.
Model: SAT RC 09
FCC ID.: P3O97802
OK
OK
IT MUST NOT BE
VISIBLE OR EASILY
ACCESSIBLE FROM
THE OUTSIDE
HOW TO FIX THE ANTENNA:
- ON METAL PARTS WITHOUT THE USE OF THE DOUBLE-SIDED
ADHESIVE MATERIAL (THE ANTENNA IS MAGNETIC)
- ON PLASTIC PARTS USING THE DOUBLE-SIDED ADHESIVE
OK
MATERIAL SUPPLIED IN THE KIT
90°
NO
OK
DO NOT COVER WITH
PARTS OR METALLIC
PAINTS
THE ANTENNA IS RESIN-
COATED AND CAN
THEREFORE BE
INSTALLED ON THE
OUTSIDE OF THE VEHICLE
(E.G. UNDER THE
OK
MUDGUARDS, IN A
HEADLIGHT......)
Fig. 11
KO
Advertisement
