Advertisement
Quick Links
F-86 SABRE
Scale EDF Radio Control model airplane
Wingspan : 1420mm
UNDER SAFETY PRECAUTIONS
This radio control is not a toy!
- Always keep this instruction manual ready on hand for quick reference.
- Assemble this kit only places out of children reach.
- First-time builders of EDF model should seek the advice of experienced modellers before
beginning assembly and if they do not fully understand any parts of the construction.
- Taking out liability insurance is recommended.
- You are responsible for this model's assembly and safe operation.
You need to purchase the following accessories separately to complete the assembly.
1.
Signal cable
(Throttle)
2.
Signal cable
(Elevator)
3.
Signal cable
(Alieron)
4.
Silicone Battery cable (No. 12AWG or 14AWG)
Copyright 2007 Fly Fly Hobby
C
1 pc required
2 pcs required
2 pcs required
1 pc required
5.
60A Electric Speed Control (ESC) w/BEC
60A
1 pc required
w/ BEC
6.
B36 Brushless Motor, 1600-1800kv,
Shaft dia 5mm
1 pc required
7.
Micro servo, 8g, torque >1.0kg
5 pcs required
8.
Li-Po Battery, 5-cells (18.5v), 3600mAh, 20C
1 pc required
Designed and Manufactured by : Fly Fly Hobby Mfg.
Model No : FF-D005
http://www.flyflyhobby.com
Advertisement
Related Manuals for Fly Fly Hobby FF-D005
Summary of Contents for Fly Fly Hobby FF-D005
- Page 1 2 pcs required 5 pcs required Silicone Battery cable (No. 12AWG or 14AWG) Li-Po Battery, 5-cells (18.5v), 3600mAh, 20C 1 pc required 1 pc required Copyright 2007 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com...
-
Page 2: Kit Contents
Warning ! First-time fliers should seek advice on pre-flight adjustments and assembly from experienced fliers. Remember that flying a badly assembled or badly adjusted aircraft is very dangerous! In The beginning, novice fliers should always be assisted by an experienced flier and should never fly alone! This model aircraft is designed to be powered by an electric-motor. -
Page 3: Horizontal Tail
1. Single cable (Throttle) 1 pc required 2. Silicone Battery cable (No. 12AWG or 14AWG) 1 pc required To ESC To ESC Throttle Battery plug Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com... - Page 4 Please refer to the retract system instruction for the installation. Air Retract system Don’t mix up the parts of left and right. The letter marked on the plywood. Nose Gear Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com...
- Page 5 Caution : As proper use of the fan unit is out of the influence of the manufacturer, the operation of the fan unit is on owners risk! This is not a toy! The unit should only be operated by childs of 12 years and supervised by an adult. Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com...
-
Page 6: Wing Construction
Fan & ESC Wing construction Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com... - Page 7 Wing construction 2mm Nut 1 x100mm rod 3 x 5 mm Linkage Stopper Fin construction Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com...
- Page 8 Never fly before checking the CG’s required position. Reposition the receiver and battery to obtain the correct CG’s location. 217 mm NEVER fly the model without well balancing. Copyright 2009 Fly Fly Hobby Designed and Manufactured by : Fly Fly Hobby Mfg. http://www.flyflyhobby.com...