Unpacking And Installation Although it is neither complicated to install nor difficult to operate your Cassette Deck- Tuner Amplifier, a few minutes of your time is required to read manual for a properly wired installation and becoming familiar with its many features and how to use them. Please take a great care in unpacking your Cassette Deck-Tuner Amplifier and do not discard the carton and other packing materials.
Features 120W OUTPUT POWER This model can deliver very high output power at less than 1% THD. VERSATILE AND EASY TO USE Incorporating all the necessary system components to provide versatility in an easy to use form : five channels of input signals. (MIC/LINE 1~3, AUX and CD/Tuner). PRIORITY AND MUTING Input to Mic 1 will activate the priority circuit which temporarily mutes signals from other inputs, tuner or tape.
Front Panel Controls LEVEL METER SPEAKER SELECTOR ETR-2112 CASSETTE DECK TUNER AMPLIFIER POWER SCAN PAUSE SCAN MODE BAND REPEAT SHUF TUNE / TRACK DISC DN DISC UP FM / AM DIGITAL TUNER % Pow - dB SIREN CHIME Bass Treble...
1. Cassette Deck Section 1. EJECT BUTTON Door to open for remving and inserting the MAGNECTIC TAPE 2. LINE OUT VOLUMNE This control is used for adjusting the volume of CASSETTE DECK 3. MODE BUTTON This button is used for selecting the PLAYBACK mode. 4.
2. Tuner Section POWER SCAN PAUSE SCAN MODE BAND REPEAT SHUF TUNE / TRACK DISC DN DISC UP FM / AM DIGITAL TUNER 1. TUNING FREQUENCY DISPLAY You can confirm the frequency of tuner through this display. 2. POWER ON/OFF This button is used for tuner power On/Off.
CAUTION RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK DO NOT OPEN DO NOT OPEN LOW IMPEDANCE IMPEDANCE SELECTOR MODEL NO : ETR-2112 MODEL NO : ETR-2112 PLEASE PLEASE DO NOT USE DO NOT USE - TIP(+) : HOT SIMULTANEOUSLY...
Page 9
Rear Panel Controls 6.7. MUSIC-ON HOLD (CD AND TUNER ONLY WITH OUTPUT LEVEL) These terminals are for connecting to the telephone system. NOTE: When the tuner or CD is turned on, its output signal is always supplied to these terminals and is not concerned with master volume.
Application Of The Antenna AM OUTDOOR ANTENNA OUTDOOR FM ANTENNA FM DIPOLE ANTENNA DIRECTION OF BROADCASTING STATION SINGLE CONDUCTOR LEAD WIRE ANTENNA AM/FM SINGLE CONDUCTOR LEAD WIRE ANTENNA Connecting the single conductor lead wire antenna of the terminal of 75 ohms(Picture). Listening to the broadcasting, fix it after desiding the location and the direction so that the receipt condition may be optimum.
(Figure 4) Before you connect the speaker, remove the power cord from the power outlet and switch the ETR-2112 power switch off. When connecting the speaker wires to the SPEAKER OUTPUT terminals, use the output terminals that are suitable for the speaker (see above figure 1-4).
Specifications AMPLIFIER SECTION Rated Output -------------------------------------------------- 120Watts(RMS) Frequency Response ----------------------------- 60Hz ~ 18KHz (+/-3dB) S/N Ratio Mic 1-3 ------------------------------------------------------- more than 60dB Aux ----------------------------------------------------------- more than 65dB THD ---------------------------------------------------- less than 1%(@ 1KHz) Tone Controls Master volume ------------------------------------ Bass +/-12dB at 100Hz Treble +/-12dB at 10KHz Input Sensitivity/Impedance Mic 1-3 ----------------------------------------- 2mV/600 ohms (Balanced)