Transmission Troubleshooting; Interference; Reset Button - Sharper Image MI603 Instructions Manual

1. If the main unit does not receive signals within the first 10 minutes, a blank
"--" appears in the OUT TEMP field on the LCD. If at any time during opera-
tion a signal is not received after five consecutive intervals, blank "--" appears.
The remote unit is either too far away or there is some interference between
the remote and the main unit. If this happens, bring the remote unit close to
the main unit and press the RE-SYNC button. The main unit will receive signals
for 10 minutes. Move the remote unit to a new location closer to and in direct
line of the main unit.
2. If the remote unit's batteries are running low, a low battery icon appears in the
OUT TEMP field. Replace the batteries.
3. If the display unexpectedly goes blank, press the RE-SYNC button on the main
unit to force the main unit to receive a signal. If this does not work, check the
following:
• The remote unit is still in place.
• The batteries in both the remote unit and the main unit are still good.
Replace if necessary.
• The remote transmitter is within range and the path is clear of obstacles or
other interference. (See "Interference" section.) Shorten the distance if necessary.
Signals from other household devices such as garage-entry controls, doorbells and
home security systems may interfere with the temperature-data transmission and
may cause temporary reception failure. This is normal and does not affect the
general performance of the unit. The transmission and reception of the temperature
reading will resume once the interference has stopped.
Press the RESET button when either the main unit or remote transmitter unit is
not operating normally.

Transmission Troubleshooting

Interference

Reset Button

14