Cobra 29 LX MAX How To Use Manual page 3

Installation
Note
Before installing the CB
radio, visually check the
vehicle's battery connection
to determine which terminal
is positive or negative. A
negatively grounded vehicle
has its negative lead grounded
to the chassis.
Note
Connecting to an accessory
fuse prevents the unit from
being left on accidentally, and
also permits operating the unit
without running the engine
when the ignition is set to the
accessory position.
Note
When connected to an
4 Connect the red lead of the DC power cord to an
accessory fuse, unit will self test
accessory 12 volt fuse or directly to the battery.
the emergency weather alert
automatically when ignition is
Connect the black lead to the negative side of the
turned on. Turns itself on & off.
vehicle electrical system. This is usually the chassis.
5
Any convenient location with a good electrical
Note
contact (remove paint) may be used.
The Clock/Timer feature needs
to be reset when connected to
a switched accessory fuse.
4
ANT
EXT MIC EXT. PTT EXT.SP.
+POWER–
Plug the power cable into the back of the unit
6
marked "Power". Be sure to observe polarity
markings.
Mount the microphone
7
bracket on either side of the
unit (driver's left) using the
two screws supplied.
The bracket should be
placed under the dash so
the microphone is readily
accessible.
1.5 2 3
NB/ANL CAL
SWR
ANL
S/RF RF
SWR
CAL
5 7 9
3
1
SIG +30dB
SQ
VOL RF GAIN
OFF MIN MAX
8
Attach the microphone cable to the receptacle on
the front of the unit and install the unit in the
bracket securely.
Installation
SCAN
TX
Note
RX
If the microphone is not
connected, audio will not
MEM WX !
be heard at the speaker.
DYNAMIKE DELTA TUNE T BACK
MIN OFF
5
CH 9/19
SWR
CAL