JDS Labs OL DAC Operating Instructions Manual

Digital-to-analog converter

Advertisement

O P E R A T I N G I N S T R U C T I O N S | D I G I T A L - T O - A N A L O G C O N V E R T E R
O L D A C
S U P P O R T
O N L I N E
C O N T A C T @ J D S L A B S . C O M
J D S L A B S . C O M / S U P P O R T
B Y P H O N E
3 1 4 - 2 5 2 - 0 9 3 6
9 : 3 0 A M - 6 P M C S T ,
M O N D A Y T H R O U G H F R I D A Y
B Y M A I L
9 0 9 N B L U F F R D
C O L L I N S V I L L E , I L 6 2 2 3 4
U N I T E D S T A T E S

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OL DAC and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for JDS Labs OL DAC

  • Page 1 O P E R A T I N G I N S T R U C T I O N S | D I G I T A L - T O - A N A L O G C O N V E R T E R O L D A C S U P P O R T O N L I N E...
  • Page 2 S E C T I O N 1 Q U I C K S E T U P S T E P 0 1 S T E P 0 2 Connect AC power adapter Connect cables to your desired digital to rear power jack (15V), then audio players (USB and/or TOSLINK), connect to wall outlet.
  • Page 3 S E C T I O N 2 C O N F I G U R A T I O N C O N N E C T I V I T Y OL DAC accepts two methods of digital input: 6/44.1k thru 24/96kHz TOSLINK 16/8kHz thru 24/192kHz* Maximum RCA Output voltage is 2.0VRMS.
  • Page 4 (i.e., use 44100 computer. Only control volume from Hz for 44.1kHz). your amplifier. OL DAC automatically selects appro- priate sampling rate in optical mode. Listen safely to conserve your hearing: To ensure an optimal noise floor, www.hearingloss.org always position audio equipment as far away as possible from wireless devices.
  • Page 5 S E T U P C O M P U T E R S E T U P OL DAC requires no drivers in Windows, Mac OS X, or Linux. Most operating systems immediately recognize and set the DAC as the default playback device.
  • Page 6 T R O U B L E S H O O T I N G USB device unable to initialize Cause: Bad USB cable or incorrect drivers Solution: Try another USB cable or refer to jdslabs.com/troubleshooting No sound in one channel Cause: Bad cable, or incorrect computer settings Solution: Check balance settings;...
  • Page 7 This equipment has been tested and found to Application for Council Directives 2004/108/EC, 2006/95/EC, 2002/95/ comply with the limits for a Class B digital device, EC.Conformity declared for EN55022:2011, EN611000-3-2, EN61000-3- pursuant to part 15 of the FCC Rules. 3, EN55024-2 J D S L A B S .

Table of Contents