Advertisement
Mains voltage selection / fuse replacement
The following work should only be carried
!
out by a qualified technician in accordance
to highest electrical safety standards. Risk of
electric shock.
Replacing the fuse
The fuse must be replaced by a 6,3AT type
(5x20mm). Never attempt to short the fuse
holder. Normally the fuse should never blow – if
it has, it is a sign of a serious fault condition.
Further investigation is needed.
Mains voltage
Altering the mains input voltage range from
115V to 230V or vice versa is done by changing
the fuses according to the figure 3 below. You
will need 1x 6,3AT for 230 V operation and 2x
6,3AT for 115V operation. Never attempt to
apply any other fuse configuration or a short
circuit condition will occur.
10
Advertisement
