Hitachi C11XMB Service Manual page 29

6-12 HIDDEN SERVICE MENU
IR REMOTE
This is the selection of projector's IR sensor type.
In case that the remote control does not function in the room where a fluorescent lamp is turned on, unckeck
either "1" or "2".
SOFT RESET
If this is executed, all of the user data is initialized.Never use it when not required.
6-13 RUN TIME window
Set operating time display method (accumulated lamp time display method)
1. Select "OPTION" from the Advance menu, then place the cursor on the "LAMP TIME".
2. Press the [ ], [ENTER] or [RESET] button.
3. Press the [Reset] button once, then press [KEYSTONE] button of the remote control for 3 seconds or
more to display the screen shown below. (The menu will close after 10 seconds if there are no further
operations.)
4. Use [ ] or [ ] to select the usage status number. (The usage status is as shown below.)
Usage status number
CP-X444(C11XMB)/CP-X440(C11XM25)
To display the OSD for "HIDDEN SERVICE MENU" set up.
By the control panel
1. Display the Advance menu by
the "MENU" button.(If EASY
MENU appears, choose "Go to
Advance menu" to display
ADVANCE MENU.)
2. Select the "OPTION" on the
menu.
3. Continue press the button [ ]
fi rst, then press the button [ ]
together with "INPUT", and hold
for 3 seconds.
RUN TIME
1234
On
OFF
No.1
Usage status number (See below)
0 ..... Total usage status
1 ..... Current usage status
2 ..... Usage status before first reset
3 ..... Usage status before second reset
||
9 ..... Usage status before eighth reset
10..... Total times of AC power on
29
By the remote control transmitter
1. Display the menu by the
"MENU" button. (If EASY
MENU appears, choose "Go to
Advance menu" to display
ADVANCE MENU.)
2. Select the "OPTION" on the menu.
3. Press the "MAGNIFY OFF"
button.
Next hold the "MAGNIFY OFF"
button for 3 seconds.
Time
12
Number of times on
11 Number of times off