Table of Contents
Advertisement
Frequently Asked Questions
Frequently Asked Questions
How long will the robot run on a full charge?
On a fully charged battery, the robot should operate for 60 minutes in standard use of
driving and observation on flat terrain. Terrain will cause this to vary.
How long will the OCU II run on a full charge?
The battery run time of the OCU II is approximately 120 minutes.
How many times can the robot and OCU II be recharged?
The robot and OCU use Lithium Polymer batteries which are expected to maintain at
least 80% of their runtime after 300 recharge cycles.
How long does it take to recharge the OCU II and robot?
The recharging times for the OCU II and robot are approximately one to three hours
depending on the current state of charge and age of battery.
Can the robot be operated in wet conditions?
The OCU II should only be used in a dry environment. The warranty and Annual
Maintenance Plan do not cover any damage resulting from exposure of the system to
water, salt water spray, hazardous or caustic chemicals, etc.
The Recon Scout XL robot is water resistant to incidental immersion in 1 foot (30 cm) of
water for up to five minutes.
Where can I find the serial numbers on my robot or OCU II?
Robot: Underside of shell, near the tail mounting point.
OCU II: Bottom of the back side, near the lanyard mounting post.
Format: Eight or nine digits with an alpha character in the fifth digit.
11
©2016 ReconRobotics
OCU II Audio/Video Out Capabilities
OCU II Audio/Video Out Capabilities
Audio Output
The OCU II is capable of receiving audio transmitted from the Recon
Scout XL robot. To listen, plug the provided volume control adaptor
into the appropriate jack on the left-hand side of the OCU II. Then plug
headphones into the volume control adaptor. Headphones approved for
Apple or Android devices will not work with the provided volume
control adaptor.
Ensure you are using headphones with in-line
volume control. There is no volume control on the
OCU itself. Be careful to test the audio volume
before using.
Audio/Video Output
The ReconRobotics Audio/Video (A/V) Out Cabling Package (sold
separately) can be used to connect the OCU II to an external
monitoring/recording device (not included). The A/V Out jack is
located on the left-hand side of the OCU II.
Once connected to the OCU II, connect the other end of the A/V Out
cable to the appropriate connector on an external device. Please refer to
the instruction card provided with the A/V Out Cabling Package for
more information.
Do not use third-party cables with the A/V Out
jack on the OCU. They will not work properly.
The A/V Out cables in the A/V Out Cabling Package are specially
designed to work with the OCU II. Though they may look similar,
cables manufactured by a third party will not work appropriately with
the OCU II.
Video Only Output
If you use the OCU II with a robot that does not have the capability to
transmit audio, you will still be able to output a video signal through the
A/V Out jack using the appropriate cable. Do not use headphones with
the OCU II unless you are controlling a Recon Scout XL robot.
4
©2016 ReconRobotics
Advertisement
Table of Contents
