Orion OFFICE PRO LCD 750VA User Manual

INSTALLATION & OPERATION

Inspection
The following items are inside the box:
● UPS unit ● User manual ● USB cable
Remove the UPS from its package and inspect it for damage that
may have occurred during shipping. If any damage is discovered,
re-pack the unit and return it to the place of purchase.

Connect to Utility Power
Connect AC power cord to utility power. Then, the UPS will start to
charge inside battery. For best result, charge the battery for 6 hours
prior to initial use.

Plug in Equipment
Battery Backup Outlets(4)
Connect computer and monitor to the "Battery Backup" outlets.
These outlets provide battery backup, EMI filtering, line
conditioning, and surge protection. Battery power is automatically
provided in case of power failure.
Surge-Protected Outlets(4)
Connect a printer, fax machine, or scanner to the "Surge-protected"
outlets. These outlets do not provide power during power failure.
CAUTION: NEVER connect a laser printer or scanner to the
battery backup sockets of UPS. The equipment may overload the
UPS.
ATTENTION : Ne JAMAIS raccorder une imprimante laser ou un
scanner pour les prises de sauvegarde batterie de l'onduleur.
L'équipement peut surcharger le système UPS.

Turn On/Off the UPS
To turn on the UPS unit, press the power switch lightly. Then, the
LCD will light up. To turn off the UPS unit, press the power switch
again. Then, display will shut off.

PRODUCT OVERVIEW

www.orionpowersystems.com
User Manual
Eng l ish / F ranç ais
1. Touchscreen LCD display
2. Power switch
3. AC input
4. Battery backup outlets
5. Surge‐protected outlets
6. USB port
7. RJ11 / RJ45
Modem/network
surge protection

LCD DISPLAY

Operation Display
NOTE: If backlight shuts off, you may activate it by touching the
screen.
REMARQUE : Si le rétro-éclairage s'éteint, vous pouvez l'activer
en touchant l'écran.
UPS
LCD
Mode
UPS
Power on
AC Mode
Overload
in AC
mode
icon will flash.
Battery
Mode
When battery level is low,
icon will flash.
Overload
in battery
mode
icon will flash.

Fault Code Table:

Fault condition LCD
Output short
circuited
Overload fault
Overcharge
Bad or severely
discharged
battery
High output
voltage fault
Over-temperature
If fault alarm occurs, please call for service immediately.
En cas d'alarme de panne, veuillez appeler pour service
immédiatement.
OFFICE PRO LCD
550VA/750VA
Description
When UPS is powered
on, it will enter this
mode for 4 seconds.
LCD information will be
displayed in the
following order when
LCD is touched.
1. Output voltage
2. Input voltage
3. Load level
4. Battery capacity
When overload occurs,
alarm will beep every
0.5 second.
Alarm will beep every
10 seconds and LCD
information will be
displayed in the
following order when
LCD is touched.
1. Output voltage
2. Input voltage
3. Load level
4. Battery capacity
When overload occurs,
alarm will beep every
0.5 second.
Solutions
Disconnect short-circuited
loads and restart the UPS
again.
Disconnect all output loads
and restart the UPS again.
Call for service immediately.
Please replace the battery.
Call for service immediately.
1. Turn off the unit and wait
for cooling.
2. Or remove excessive
loads and wait for
cooling.