Option 2: Usb Extender Direct Surface Mounting - Icron Ranger 2324 User Manual

OPTION 2: USB Extender Direct Surface Mounting (using your own hardware)
The bottom of the enclosure features four pre-drilled holes for optional surface mounting.
1. Mark the center point of each of the four holes on your mounting surface either by directly measuring or
using a print out of the stencil below.
2. Hardware recommendation: M3.0 locking washers and M3.0 screws (4 of each per extender) noting
screw length will depend upon thickness of mounting surface.
3. Drill through each of the four hole markings on the mounting surface using a 4.7625mm (3/16") drill bit.
4. Align the bottom enclosure holes to the newly drilled out holes on the mounting surface.
5. Place a locking washer on each of the four screws and using a screwdriver, fasten the extender into place.
To ensure the stencil below prints to scale be sure to set the page scaling setting to "none" .
4.8mm (3/16' ' )
(4 Places)
mounting hole
Direct Surface Mounting Measurement Stencil
42.0mm (1.6535' ' )
Distance between the enclosure mounting holes:
42.0mm x 77. 0mm
77.0mm (3.0315' ' )
10